Journey with Confidence RV GPS App RV Trip Planner RV LIFE Campground Reviews RV Maintenance Take a Speed Test Free 7 Day Trial ×
 


Reply
 
Thread Tools Search this Thread Display Modes
 
Old 09-11-2017, 05:00 PM   #1
Junior Member
 
Join Date: Sep 2017
Posts: 17
Awning Positions?

Have a NEW Redwood 3901MB with two awnings. Question....should I be able to change the pitch of the awnings? They go out completely flat and was wondering if they are adjustable to angle down a bit? I'm a "Newbe" to RV'ing! Thanks for any replies.
RonLaDuke is offline   Reply With Quote
Old 09-11-2017, 05:27 PM   #2
Junior Member
 
TonynMarti's Avatar
 
Join Date: May 2017
Posts: 12
Yes you can change the pitch. I have the exact Redwood and have already changed the pitch. If you look at the main arms coming from the side of your camper you will see a small spring loaded pin that protrudes through the sides both main arms. You can push this pin inward toward the center of the arms until it clears the outside casing and then slide the outer arm either up or down depending on which way you want the pitch to go. It has hardly any pressure on the arms when you push the pins inward. Just make sure there is not a lot of wind blowing at the time you do this so that you can control the awning whether you want to slide it up or down.
TonynMarti is offline   Reply With Quote
Old 09-11-2017, 05:44 PM   #3
Junior Member
 
Join Date: Sep 2017
Posts: 17
Thanks...I saw those buttons there but thought there should be one on both sides of the rail to work? Just tried one and it slides smoothly....They are set to be straight out now, is there a "Favorite" setting you use?
RonLaDuke is offline   Reply With Quote
Old 09-11-2017, 05:51 PM   #4
Junior Member
 
TonynMarti's Avatar
 
Join Date: May 2017
Posts: 12
I have been using the second down from the top. I guess it would be a matter of preference. I do know that it doesn't take a lot of wind to raise my canopy up now that I have tilted it downward. It may be just me but I now anchor it with a bungee on both ends with a little tension to help keep it down so it doesn't raise or lower with the wind.
TonynMarti is offline   Reply With Quote
Old 09-11-2017, 06:15 PM   #5
Senior Member
 
travelin' texans's Avatar
 
Join Date: Sep 2012
Posts: 3,353
Mine are set at the most pitch possible with the center arms of both awnings 1 notch up so the water runs away from door. You can set however you prefer as long as there is not more than 3 holes difference between front/rear arms & still roll up normally. You DO NOT have the change pitch settings to roll them up, set them as you like & leave them.
__________________
Danny & Linda
Full-timed 10+ years
Former '13 FB owner
Traded '13 GMC Denali DRW D/A
Currently rv & truckless
Replacement undetermined
travelin' texans is offline   Reply With Quote
Old 09-11-2017, 07:01 PM   #6
Junior Member
 
Join Date: Sep 2017
Posts: 17
Thanks to both you folks, I appreciate your quick response....I think I will find this site very helpful going forward!!
RonLaDuke is offline   Reply With Quote
Old 09-12-2017, 02:26 AM   #7
Senior Member
 
atom ant's Avatar
 
Join Date: Feb 2013
Posts: 7,101
You can offset the pitch so one side is further down than the other side, but I believe the manual said only by a couple of increments or it won't roll up even.
__________________
Brad & Dory - Lone Tree, CO
CURRENT - 2013 Itasca Meridian 42E/2013 Wrangler 4dr Sahara
SOLD - 2014 Redwood 36RL/2014 F350 DRW
atom ant is offline   Reply With Quote
Reply



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


» Featured Campgrounds

Reviews provided by

Powered by vBadvanced CMPS v3.2.3
Disclaimer:

This website is not affiliated with or endorsed by Redwood RV or any of its affiliates. This is an independent, unofficial site.


All times are GMT +1. The time now is 06:09 AM.


Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
×