Bedroom Slide Problem

[bruce byram]

My bedroom slide failed to close properly. Upon closing one side fit tight against the trailer wall the other was about two inches out. I opened the slide and closed it and it closed tightly. Then during a trip, each night, when pushing the extend button it would stall and not open. Closing it and then reopening would usually work after several tries. Finally I discovered that it was tweaking and if I would pull on the slide from the outside while my wife pushed the extend button it would work. Now it will not work no matter how hard I pull on it. Has anyone else had this problem and if so what is the solution?

[RWJSIM2003]

Bruce
What year and model of RW do you have? Do you have cable slide or Schwintek elec gear drive? is the slide in a slide? Need more information to be able to assist

[travelin' texans]

If you have the Schwen Tech (little gears) you need to recalibrate it, extend it a couple of inches then retract it doing this 3-5 times should help. When extending or retracting be sure to continue to hold the switch down for 3-5 seconds after its fully extended/retracted. Also use silicone spray to lube tracts & motors, there are post with videos on this procedure,

[bruce byram]

Sorry for the lack of info. My Redwood is a 2012 yr. 31SL with the electric bedroom slide. I'll try your suggestions but because it does not respond, even when I pull on it I'm worried that I can't do the other things suggested.