When I pull in my slide outs they do not come all the way in flush with the OUTSIDE . They are about onehalf to three quarters of an inch still out and there is absolutely no room inside for them to come in any further. Is this normal on the Redwood?
I thought the same thing, then started looking & asking around as I have about 1/3-1/2" on all my slides. Looking around most have gaps as there is a seal on the outside so once it's pressed tight the Wilde should be all the way in. Apparently the only slides that actually get flask are the Prevo busses (&similar busses). Ihave yet to see a retracted slide that didn't have at peat a 1/4", so I guess it is normal. I do think that 3/4 seems like an excessive amount I didn't actually measure mine. There are adjustments that can be made so it's not likely a big issue should it be to wide.
Perhaps more of an issue than one might think. My slides cannot come in any more or they will be touching the inside walls or center isle. This must be the way they are suppose to be. Thanks for the help.
Linear Mode
