Wiring harness under slide

[GWHoll]

Anyone had a problem with this? The harness that holds the wires on the "opposite door side" front slide on my 2012 36FL has a metal angle iron piece that is loose and keeps showing up in front of my chairs when I move the slide out. I think there is one romex wire attached to this harness. It is very hard to get to due to not much room between the slide and the bar/cabinet between the living area and kitchen. Looks like the only way to put this back would be to remove the chairs and some how open the raised carpeted area and screw it back in it's spot. I can't seem to find any screws holding the edge of the carpeted area down to the top part of the carpeted area. I'm concerned the angle area is going to cut my carper or my chairs soon, so I need to get it fixed. Anyone have any suggestions?

[Grizzby]

We had the same problem on our 2012 36FL. In fact, on our delivery day when they put that slide out, it did slice the carpet (which the dealer replaced). There are screws that hold that front piece on...they are well hidden in the carpet. Once you find and remove the screws, you can fold that piece back to get access to the wiring bracket.

Bob

[GWHoll]

Thanks for the info

[rob_fla]

I had problems with both of the front slides on my 38FL.
When I would open and close the slides, the wires would come out from under the slides and could be seen on the floor.
Had to remove the front of both slide floors and correct the poor workmanship myself.