Slide Adjustment, Marring Linoleum Inside

[Scraper]

Need som advice on how to adjust slides. On My 3901MB, on the drivers side, the front of the slideout is marring the floor. Looking at the adjustments for the front slide mechanism, does moving the outboard adjuster up or down cause the inboard of the slideout to put less or more pressure on the floor? From the picture attached, you can see where the adjuster has been moved (I bought this RV used) and the horizontal bolts were a little loose, but the vertical adjuster/stop is tight. I’m trying to figure out if I can adjust out the problem and how to do it.

0D6B7890-798D-4F3D-85B5-89B6FA24B74A.jpg

[r time soon]

Lippert has a sheet for doing the adjustments. Just remember to make small adjustments and then check the slide out in the travel position versus the extended position to see what difference there is, because any adjustment will effect both in and out position. Good Luck

[Scraper]

Thanks for the Adjustments document. So does the “vertical adjustment” adjust the inside of the slide up or down so that it doesn’t rub hard on the linoleum floor, or does that only adjust the exterior of the slide so it matches the exterior wall when closed?

[Germans]

Following. Have mine doing very similar. Look to be sagging where pantry and stove area is. Curious what you find works. I downloaded instructions also.