Sheelister,


Thank you very much for the comments about listing part numbers and part sources for parts for sharing with the Redwood community. We need to add tips too, like for the case here!

Here is the method for installing the slider:
1. Remove the two quarter inch plastic button caps on the "edge" of the door just above the black handle latch.
2. Remove the two screws that hold the slider support top bar in place.
3. Gently remove about 8 inches of screening on the top and bottom of the top support bar. Pull the small rubber screen rib out enough so you can raise the top support bar upward a bit
4. Gently move the top support arm upward about one inch. This will allow you to insert the clear plastic door slider.
5. Reassemble in reverse order of the steps above. You'll need a screen removal/insertion tool.
That's it ... simple after you do it once!😃

Good luck and stay safe,
Ozzie